Put an end to corrosion, rust, and pitting!
- Protects metal, paint, plastic
- Shiny, clear finish
- Resists salt, humidity, water, and UV
- Will not rinse or rub off
|
S100 Total Cycle Corrosion Protectant blocks out rust! It creates an invisible barrier coating over the surface of your motorcycle that takes the brunt of any attack by water, moisture/humidity, salt air, road salt, road grime and mag chloride. S100 Total Cycle Corrosion Protectant prevents corrosion by blocking the causes of corrosion!
In order to protect a surface from the elements, you need a coating or a film that covers the surface you want to protect by sealing out the things that want to attack and corrode the surface. S100 Total Cycle Corrosion Protectant provides this durable, clear coating that is water-resistant and resists rubbing off.
S100 Total Cycle Corrosion Protectant provides strong protection against mag chloride and road grime. Mag chloride is short for liquid magnesium chloride. Mag chloride is sprayed onto roads during winter months to prevent snow and ice from sticking to asphalt and cement roads. While it helps ensure drivers' safety, it corrodes steel, chrome, rubber, copper, (as in copper wiring), and many other parts of your motorcycle.
Road grime is anything on the road like motor oil, transmission oil, brake fluid - the fluids commonly deposited on our roads - mixed with water from the rain, and then splattered onto your motorcycle every time you get caught riding in wet weather.
S100 Corrosion Protectant creates an invisible barrier coating which helps prevent anything corrosive from attacking your motorcycle. Without protection, metals will rust and chrome become pitted. If this happens, the only way to correct it is intense polishing or, in the worst case scenario, re-chroming the affected part. Keep your motorcycle looking good from the start with S100 Corrosion Protectant. It's the only way to truly protect your investment.
S100 Corrosion Protectant can also be used on plastics, vinyl, finished leather and synthetic leather to protect them from UV rays.
When it comes to maintaining your bike’s appearance and resale value, the best and most efficient use of your time is to practice preventative maintenance. It’s faster and easier to spray on a coating of S100 Corrosion Protectant than it is to undo the damage caused by rust, oxidation and corrosion. S100 Corrosion Protectant is a great preventative maintenance product that should be in every motorcycle owner’s garage.
7.2 oz. - aerosol
How to use
Simply spray the area to be protected with a mist of S100 Corrosion Protectant. After misting an area to be protected, rub the protectant over the surface and into the surface thoroughly using a clean, dry microfiber towel until the surface is dry and has a high shine.
Results
The coating left behind is a transparent film that is invisible to your eyes. It won’t leave the surface cloudy or opaque and it will actually increase clarity or shine on most surfaces.
Extended Storage Tip
If you’re going to be storing your motorcycle for an extended period of time, spray a thicker coating onto the areas or components you want to protect and allow this coating to remain; that is don’t wipe off the excess.
When bringing your bike out of storage, wipe all the coated areas with a clean microfiber detailing towel to remove any excess product. This is important as while the S100 Corrosion Protectant was protecting your bike from corrosion, air-borne dust might have landed on the coating and you want to wipe the Bike clean before starting the engine. This will remove the excess product while restoring a showroom-new shine.
 Federal regulations prohibit the shipment of aerosol products by air. This item is shipped via UPS Ground only.
|
|
